2016 Honda Accord Coupe L4-2.4L (K24W1) Lubricants, Fluids Tables


2016 Honda Accord Coupe L4-2.4L (K24W1) Lubricants, Fluids - General Information

Always use manufacturer recommended fluids and lubricants for your Honda vehicle. By using the proper fluids and lubricants in your Honda, you will prevent warranty loss, extend vehicle life, protect your engine and parts, and also have a better driving experience overall.

Table: 2016 Honda Accord Coupe L4-2.4L (K24W1) Lubricants, Fluids

Application
Lubricant or Fluid
Engine
Honda Motor Oil: 0W-20
Look for the API certification seal on the oil container.
Make sure it says ‘‘For Gasoline Engines.’’
SAE Viscosity: See chart.
Manual transmission
Honda ManualTransmission Fluid (MTF):
Always use Honda MTF.
Using motor oil can cause stiffer shifting because it does not contain the proper additives.
Automatic transmission
Honda Automatic Transmission Fluid (ATF DW-1):
Always use Honda ATF DW-1.
Using a non-Honda ATF can affect shift quality.
CVT
Always use Honda HCF-2.
NOTE: Using the wrong type of fluid will damage the transmission.
Brake system (including VSA lines)
Clutch system (manual transmission)
Honda DOT 3 Brake Fluid:
Always use Honda DOT 3 Brake Fluid.
Using a non-Honda brake fluid can cause corrosion and decrease the life of the system.
Cooling system
Always use Honda Long Life Antifreeze/Coolant Type 2.
NOTE: For prolonged cold temperatures below -22 °F (-30 °C), add Honda Extreme Cold Weather Antifreeze/Coolant Type 2 (concentrate).

For the details of the lubrication points and the type of lubricants to be applied, refer to the illustrated index and the various work procedures (such as Assembly/Reassembly, Replacement, Overhaul, Installation, etc.) contained in each section.

Application
Lubricant or Fluid
A
Brake booster clevis pin
Multipurpose grease
B
Battery terminals
C
Clutch master cylinder clevis pin
(manual transmission)
D
Fuel fill door
E
Hood hinges and hood latch
F
Trunk hinges
G
Caliper pins, caliper pin boots, and
caliper piston boots (AKEBONO)
Honda caliper grease: P/N 08C30-B0224M
H
Caliper piston seals (AKEBONO)
Honda DOT 3 Brake Fluid

 

Application
Lubricant or Fluid
I
Caliper piston boots (NISSIN) and
caliper piston seals (NISSIN)
Honda silicone grease: P/N 08C30-B0234M
J
Change wire ends
(manual transmission)
K
Slave cylinder push rod
(manual transmission)
Super high temp urea grease: P/N 08798-9002
L
Air conditioning compressor
Compressor Oil: DENSO ND-OIL8 (P/N 38897-PR7-A01AH)
for refrigerant HFC-134a (R-134a)

NOTE:

  • Lubricate the following areas using the recommended lubricants and fluids.
  • In corrosive areas, more frequent lubrication is necessary.

 

2016 Honda Accord Coupe L4-2.4L (K24W1) Lubricants and Fluids (KA/KC)