Toyota Sequoia Lug Nut Torque Setting | Sparky Express

Toyota Sequoia Lug Nut Torque Setting

What is the lug nut torque setting for Toyota Sequoia?

When installing a wheel on your Toyota Sequoia, you must torque the lug nuts to the manufacturer's recommended lug nut torque of:

  • 2008-2021 Toyota Sequoia Models: 97 ft-lb, or 132 Nm (you can go as high as 100 ft-lb).
  • 2001-2007 Toyota Sequoia Models: 83 ft-lb, or 113 Nm (you can go as high as 85 ft-lb).

To properly tighten your wheel nuts to the manufacturer's recommended specs of 97 Ft-Lbs (132 Nm) for 2008-2021 models or 83 ft-lb (113 Nm) for 2001-2007 models, you will need an accurate and properly calibrated torque wrench. Please make sure that the wheel nuts or bolts are torqued while the wheel is "in the air" but the vehicle has been lowered, which means the wheel has to be as close to the ground as possible, almost touching the ground or pavement (use wheel chocks to stop the wheel from spinning when torquing the wheel nuts or bolts). This is to ensure proper torque reading and wheel setting.

For safety reasons, in order to avoid vehicle damage or personal injury, proper lifting equipment is required when torquing the lug nuts on your Toyota Sequoia. Only use the jacking points indicated in your Toyota Sequoia Owner Manual, and always activate the emergency brake before jacking the car. In addition, use jack stands properly placed under your vehicle when leaving the car suspended for a while, or if you have to get under the car for any reason.

Do not over-torque or under-torque the lug nuts on your Toyota Sequoia!

If you require roadside assistance for your Toyota Sequoia, we can help! The following services are available from Sparky Express in Toronto GTA area:

Sparky Express is an independent, on-demand roadside assistance provider. Our roadside assistance services are available for booking online, or via telephone.